I've been spending the past couple of months in Tokyo. Worried about the radiation, I brought my DRGB-90 russian geiger counter /dosimeter that I had bought a couple of years ago. Unfortunately, the DRGB is a rather old analogue design and the readings at low (natural background radiation) are rather imprecise. There's an application on iOS called Geigerbot that is a sophisticated click-counter. Set up correctly, it can give you precise microsievert per hour readings. It also interfaces with Pachube which allows historical readings. Now Geigerbot can use the microphone on your iPad/iPhone to detect the geiger counter's audible clicks, but it will of course also pick extraneous external noise. I wanted to directly interface my DRGB-90 with my iPhone so I could have more precise readings. Unfortunately, the DRGB doesn't have an external speaker jack or any other outputs. Here's how I hacked it. |
Step 1: Take it apart
It's very important to note that geiger counters produce very high voltages (400 volts in the case of DRGB-90). Before opening the case, remove the batteries. This is what it looks like on the inside. The long cylinder is the SBM-20 geiger-muller tube. It came wrapped in aluminum foil from the factory in order to give it better shielding against beta radiation (in order to emphasize gamma radiation).
I was disappointed to not see the speaker when I opened it up. Hmm, it must be on the back side of the printed circuit board. The board didn't up easily, it took some wrenching
Step 2: Under the PCB
Lifting up the PCB (with the help of a sharp scoring knife to break the PCB conformal coating). The piezo speaker becomes visible. I wanted to patch into the speaker. Using my multimeter, it becomes clear that the piezo speaker frame is grounded to ground and there's a small (almost invisible in the photo) lead to the piezo.
Step 3: Patching into the speaker output
I cut the speaker output lead and soldered in my own lead.
Step 4: The speaker jack
I then hacked in my own headphone jack using the lead from the piezo speaker as the positive terminal and the battery ground as the ground. On the headphone jack end, I used the necessary bypass capacitor and voltage dividing resistors that the iPhone needs to recognize a microphone input, as noted on the Geigerbot homepage. I could have built this into the unit itself if I had thought a bit more about it. In order to reduce the output to iPhone mic-in levels, I used the 100:1 voltage divider circuit on Higuchi's page, but the volume levels were a bit low in Geigerbot, so I later changed it to 40:1 by swapping out the 100K resister.
Step 5: Putting it all together
Here it is all put together and hooked into my old iPhone 3G which had been previously destined for the dust box.
The iPhone then connects into my Pachube account for a real-time and historical data feed.
Recent Comments